MCU temperature: min 38.7, current 38.9, max 38.9
SD card longest block write time: 0.0ms, max retries 0 Last software reset at 16:16, reason: User, spinning module GCodes, available RAM 6660 bytes (slot 2) RepRapFirmware for Duet 2 WiFi/Ethernet version 2.02(RTOS) running on Duet WiFi 1.02 or later Now I'm working on pressure advance on it's MK10 nozzle setup. I'm liking the absence of a reconnect button and request vs. So far so good, I had to flash the firmware differently than described, I uploaded both the web and Duet firmware at the same time, then uploaded just the duet firmware again and then hit "yes, update firmware" and boom, off it went.
WiFi signal strength -72dBm, reconnections 0, sleep mode modem WiFi Vcc 3.35, reset reason Turned on by main processor Responder states: HTTP(0) HTTP(0) HTTP(0) HTTP(0) FTP(0) Telnet(0) Telnet(0)įailed messages: pending 1333, notready 0, noresp 0 Hiccups: 0, StepErrors: 0, LaErrors: 22, FreeDm: 178, MinFreeDm 150, MaxWait: 0ms, Underruns: 229, 0 Supply voltage: min 24.1, current 24.3, max 24.7, under voltage events: 0, over voltage events: 0ĭriver 2: standstill, SG min/max not availableĭriver 3: standstill, SG min/max not availableĭriver 4: standstill, SG min/max not available MCU temperature: min 38.2, current 39.6, max 39.7 SD card 0 detected, interface speed: 20.0MBytes/sec Last software reset at 20:06, reason: User, spinning module GCodes, available RAM 6404 bytes (slot 3) RepRapFirmware for Duet 2 WiFi/Ethernet version 2.0(RTOS) running on Duet WiFi 1.02 or laterīoard ID: 08DGM-9T6BU-FG3SN-6JKD4-3SD6S-TUZHD
It seems to operate fine, but I do seem to get random ribbing at times. I notice that I get LaErrors when running M122 So I've had this board for a little while on my FT-5 R2, it's working well I'm still fine tuning it.
0 kommentar(er)
